And’ a very compact and practical WT in ’ use supplied power stack.
Recommended for those who have problems to lifts and humidity need to monitor wall areas that should be treated.
Does not require initial calibration and fits for the measurement of moisture of the superficial layers of masonry, of wood and porous articles.
The ’ is very simplified usage it has LCD display 2 digit for reading and side button and power measurement.
The measure is in proportion to the volume therefore a totally saturated d wall water ’ can hardly reach levels that exceed the 35 – 37%
Damp walls should be considered all values that exceed the 20% While can be considered dry all surveys that are less than 7 – 10%
For ’ use remove the CAP that protects tips and, starting from the bottom, carefully slide the power light in the wall by activating the button for the measurement.
Proceed similarly rising every time 20 the 30 cm and write the measurements down to create a complete and detailed map of the State of the wall wet.
How to act
First get an idea of the value of humidity on dry wall by measuring at a height of more than 2 m (where probably the wall should not have been reached by the ’ moisture).
Use that value as the baseline of its wall in relation to the environmental relative humidity ’.
Then mark with a pencil all building areas that exceed this value, then deal only with IgroDry for risanarle.